B'ham to Derby reaches Tamworth

[jetgriff]

Got all track and scenery in between Saltley and Tamworth. (Well the hump yard at Washwood Heath up sdgs and the down Washwood Heath sdgs still need some more sidings).
56 trip with a coal train goes perfect from Kingsbury to Waswood Heath via the slow lines, all signals working ok, but the junction signals guarding the main double track junctions still have to be sorted out, I am using the actual layout detail that I remember along with photo's so getting the RS signals perfect is a bit of a task although the trains run good on the main lines. Will take the .rpk pack of the route to my mates and if it loads ok into his RS I will upload here..


Click the image to zoom in

[jetgriff]

progress report, I went to my mates installed the route and the extra wagons and scenery pieces, it loaded good and put in the .rpk file of the route, that went in ok and opened up in the scenario selected, but the engine fwd, rev, open, shut, brakeson/off all seemed to be coneted to the A and D key... remembering the usa keyboard I switched to the UK one but still the same, so I uninstalled the whole lot and reinstalled it without my addon but the problem was still there. He has a new 2.8 dual core computer (but its a lot slower on FPS than my 2.2 Athlon CPU.. shocking in fact) So I dont know what to do next as to testing.. any suggestions please?

[ianm42]

Sounds like Simple Controls selected instead of Intermediate or Expert.

[jetgriff]

I dont think the fault was in the new route, everything else was working good, even the A1 traffic, just could not control the loco with any sense