dam ash tree will not delete

jetgriff · Post by **jetgriff** » Sat Jan 19, 2008 10:37 pm

just done a lot of work ... but not saved for 10 mins, now I have a Tree ash mid 01 stuck in the track and this will not delete, any way round this

tads1970 · Post by **tads1970** » Sun Jan 20, 2008 12:53 am

Hi,go into your editor,zoom to the tree,go under the earth and look up,you might have to zoom in a fraction more so you dont highlight the track-i get this when using linear bridge's seated just below the track.It's tricky but do-able.

Daz

jetgriff · Post by **jetgriff** » Sun Jan 20, 2008 3:45 am

no, no way can I get it to 'highlight', it seems to be just a 1d image, its only about 1 mil across underneath..

RSderek · Post by **RSderek** » Sun Jan 20, 2008 10:05 am

click on the floor and draw am area circle around it, I have a feeling this tree does not have a bounding box.

If memory serves me right this is a forward facing poly.

if this is the case I should be able to fix very easy and get back to you, let me look.

regards

Derek

iceman2117 · Post by **iceman2117** » Tue Jan 22, 2008 7:43 pm

hi, ...

..look who is the Axis- Euler in Original Mesh (Modeller). Then click in RS Editor who is the Mesh Axis Euler(Modeller Pose)
Press Del.

greets ice

Atomic Systems

dam ash tree will not delete

dam ash tree will not delete

Re: dam ash tree will not delete

Re: dam ash tree will not delete

Re: dam ash tree will not delete

Re: dam ash tree will not delete