Sky! Conductor 2

ACE2K1 · Post by **ACE2K1** » Sat May 11, 2002 9:24 am

I want to use Sky! Conductor 2 with the S&C 1930s route. The only problem is that instead of using skies like sun.eng, the route uses UKsun.eng so Sky! doesn't replace these files, and therefore the new skies don't show. Is there something I can change in one of the route editors to make it use the skies with the original filenames ?

Thanks

simuk · Post by **simuk** » Sat May 11, 2002 10:03 am

rename the uksun.eng file, run sky conductor 2 so it installs the sky, and then rename the file back to uksun.eng ? Don't know if that'd work, but that what I'd try.

MikeMKD · Post by **MikeMKD** » Sat May 11, 2002 12:52 pm

Hi
Have you used the route adder to add the route to the sky2 info? add_route.exe in the folder.

Mike.

saddletank · Post by **saddletank** » Sat May 11, 2002 4:19 pm

Not sure what you are doing. I installed Sky conductor 2 on the 1930s S&C without any problem.

ACE2K1 · Post by **ACE2K1** » Sun May 12, 2002 3:24 am

I've added the route using Sky Conductor 2 route adder, and althought I'm doing things right, it looks as though I might have a different version of the route.

BobLatimer · Post by **BobLatimer** » Sun May 12, 2002 4:47 pm

I had the same problem. It installed ok for the other routes but not the S&C 1930.

There is an updated version of Sky Conductor (2.6 I think) on the howintheworld website that I downloaded yesterday. It works on all of the routes I have.

basildd · Post by **basildd** » Sat Jun 15, 2002 12:04 am

Yep - works fine on all mine too!