Gatwick Express takes wrong turn

gordon_walter · Post by **gordon_walter** » Sun Nov 21, 2004 11:42 am

Hi, I'm new to using this forum.

I'm doing an activity on LBE using the Gatwick express, I've set up a service from Gatwick to Victoria! For some reason one and only one of the services decides not to take the turn after Clapham for Victoria and continues on STRAIGHT to the next signal where it just stays for the remainder of the activity! All the services before and after take the correct path, but this one does not, anybody any ideas?

SCOTTLOWES · Post by **SCOTTLOWES** » Tue Nov 23, 2004 10:04 pm

Try this...

1. Go into activity editor
2. Find on the map where the train turns off
3. If it is going the wrong way then there will be a green dot
4. Click on the traffic edit button then delete the service which is wrong
5. Click on the drop down service box
6. Click on the service you have just deleted
7. Then click on edit
8. Then below the path box click edit
9. And on the green dot that is there
10. Right click and click on take other exit

And this should

work

gordon_walter · Post by **gordon_walter** » Tue Nov 23, 2004 10:53 pm

All the trains are using the exact same service and path, just entered at different times in the AI! This train in particular is taking a different path which is not used in any other service! The trains before and after it use the same path and service!

jbilton · Post by **jbilton** » Tue Nov 23, 2004 10:59 pm

Hi
I would delete that service from the traffic file...save...then go back into AE...and set that service up again....that should clear it.

gordon_walter · Post by **gordon_walter** » Fri Nov 26, 2004 12:43 am

I deleted the path and service and remade it, but yet again the train is taking the wrong turn

!! Can anyone explain this?

southcoasttrains · Post by **southcoasttrains** » Fri Nov 26, 2004 2:00 am

Probably wants to do a Stewarts Lane ECS rather than a Viccy pax run lol.