Those gentle arches sorted

Buckeye · Post by **Buckeye** » Mon Jan 05, 2004 3:58 pm

Hi All

Sorted those arches with the Extrude Tool.

Easy when you know how.

Buckeye.

mikesimpson · Post by **mikesimpson** » Mon Jan 05, 2004 10:30 pm

I used the boolean 'Subtract' operation on a bridge I built a while ago, top of the bridge was just an elongated cube, then placed a cylinder of appropriate height/diameter crossways under the cube and subtracted it leaving a nicely rounded arch.

I then built the bridge piers as separate pieces.

Buckeye · Post by **Buckeye** » Tue Jan 06, 2004 8:43 pm

Hi Mike
Thanks for the info. Will try that method when time permits. My efforts where to produce a plug that could be used on all arches with the same radii. My plug is 20mts long to accomidate all skew type bridges.

As the route expands the progress becomes slower.
Joe's Law.
This is better than Hornby.

Regards
Joseph Pearson