RhB Surselva Line (Chur-Ilanz) Beta V1.0

[holzroller]

Now available, not it has some signalling issues https://rail-sim.de/forum/wsif/index.ph ... Z9uuyaESyY

[jpvdveer]

Thank you! Note the heavy payware requirements - Thomson Albula, Arosa, Bernina; Rivet Survelva; SimTrain SBB route 1; JustTrains Three Country Corner Route are all required for route assets.

[smarty2]

Fantastic.

[JohnM1945]

Very attractive! A pleasure to drive - and (for me) no set-up problems whatsoever.

Yes, you'll have to TAB past quite a few red signals, but this IS a Beta and the signalling problem has been (ahem) signalled.

John M

[rabidcirquefan]

This looks great! I didn't purchase the Surselva Line, but if there's a companion line added on to this version that takes it from Chur to Thusis, I'd definitely purchase to get the assets needed.

[jpvdveer]

This route has, for the time being, been removed from the rail-sim.de download area as apparently Simtrain is unhappy about the use of their assets (through mere referencing!) in the route. I separately was unhappy about the use of SBB Route 1 assets as this route is very old and still relatively expensive, so not a very good investment. Hopefully a new version will come out in which this route is no longer a requirement.

[JohnM1945]

My sympathies to all concerned...

But, most of all, my encouragement to the route creator. I'm sure a way can be found round the copyright issues, quite possibly by selection of suitable substitute Assets. Please persevere with this route in particular - and route building in general. The evidence so far is that you're brilliant at it!

John M

[smarty2]

Glad I got it when I did! I agree there must be better assets out there as the SBB1 was pretty dire on release imo.

[smarty2]

Had a run finally down this route and have to say that beta signalling issues aside this is an incredibly well put together route, I doth my cap to the author.