Swapping catenary?

[smarty2]

Had a look on the tutorials page about swapping catenary, noticed there was one about removing it but what I would like to know is how can I swap out the catenary used in the Albula v2.b route for Thomsons Albula one? Is it even possible... Also Signals, I'm guessing that is a whole different kettle of fish?

[37114]

Had a look on the tutorials page about swapping catenary, noticed there was one about removing it but what I would like to know is how can I swap out the catenary used in the Albula v2.b route for Thomsons Albula one? Is it even possible... Also Signals, I'm guessing that is a whole different kettle of fish?

Yes. The process would be the same for swapping track or indeed any asset. The tutorial on swapping track will help you.

[mikesimpson]

Catenary swapping might be possible, but would depend upon them being exactly the same size and height as the ones you were replacing. Try swapping a few on a clone of your route?

As for signals, I doubt if this is possible as you would need to swap exactly the right type for each junction.

[smarty2]

Thanks Mike, think I will leave it to the professionals!