When a fenceline, which should be STRAIGHT, arches upwards, from it's start-point, to it's end-point, and needs to be removed, and re-laid, before being done correctly ? The fence is still perfectly straight, before it rises upwards, at about roughly 40/45 degrees angle. How do you stop it doing this, if it's happened to you, before ?
Regards...
Jim Mcdermott
Does anyone have any idea what causes this ?
Moderator: Moderators
-
Halbers
- Been on the forums for a while
- Posts: 275
- Joined: Wed Oct 16, 2013 1:49 pm
- Location: Cossington, Somerset
Re: Does anyone have any idea what causes this ?
Hi Jim,
Have you accidentally pressed the "snap to terrain" button ? If so, turn it off and it should be fine.
Check that the loft gradient is set at zero and you will get a horizontal fence.
Steve
Have you accidentally pressed the "snap to terrain" button ? If so, turn it off and it should be fine.
Check that the loft gradient is set at zero and you will get a horizontal fence.
Steve
Re: Does anyone have any idea what causes this ?
Hi mate...
That's worth a try, and I had a look at my screen all over, and I think this same thing actually happened to me in the distant past, but it seems I had forgotten what the fix for this was. It was very rare, but I do recall it. I got help, and it worked, then. I think i must have accidentally pressed something I didn't intend to, by mistake, but will need to remember thid, next time, if I can !
Regards...
Jim McDermott
That's worth a try, and I had a look at my screen all over, and I think this same thing actually happened to me in the distant past, but it seems I had forgotten what the fix for this was. It was very rare, but I do recall it. I got help, and it worked, then. I think i must have accidentally pressed something I didn't intend to, by mistake, but will need to remember thid, next time, if I can !
Regards...
Jim McDermott