Reskins not functioning properly

mikesimpson · Post by **mikesimpson** » Sat Jun 13, 2015 11:25 pm

Thanks for the comments above and I realise that hiding the reskin distribution code among the Blue Peter reskin download would mean that not everyone looked at it, especially those who are not ex-LNER fans and those who live in the South of England (anywhere south of Newcastle

).

I will put together a new package with just the program and instructions for the script file and get back to this later in the week, so that those interested can test it.

Mike

kenbalfour · Post by **kenbalfour** » Sat Jun 13, 2015 11:28 pm

Hi Trev
There are two versions of Richards 319 NSE reskin, one for the original RSC version and a different one for for the Bed Pan line version. The installers put them in their correct folders, that is RSC for the original and DTG for the Bed Pan version.
You must run the install bat file after installing the RWP.

Ken

Trev123 · Post by **Trev123** » Sun Jun 14, 2015 12:02 am

Ok thanks.

luigi1605 · Post by **luigi1605** » Thu Oct 15, 2015 12:41 pm

I know this is an old post but I found out a while ago that the WCRC 57/0 was refencing the default 57/0 for me not the railtours input file. That was what was causing my problems. Same with the 350/450 as the centre cars needed the input mappers assigned. Not sure why but it worked for me

Atomic Systems

Reskins not functioning properly

Re: Reskins not functioning properly

Re: Reskins not functioning properly

Re: Reskins not functioning properly

Re: Reskins not functioning properly