Class 92 TVM430

[davidlewis]

Hello everyone,
Despite the heated debates regarding the recently released class 92, I quite like it!

One thing I would like to ask though is, has anyone been successful in getting the class 92 to work properly with the TVM signalling?

I attempted to model the "Polish Train" (4Q20 Ripple Lane to Dollands Moor) so upon joining HS1 on the southbound connection, I was greeted with the red squares and emergency brakes were applied.

I thought nothing of this at first and thought it must be because I'd just joined the line but every mile or so I get the same happening and thus a brake application occuring. I was on a free roam scenario so no other trains were about but I didn't get above "80" on the TVM signalling display.

What am I doing wrong or is this a known bug?

Tom

[MallardFan]

I have run the 92 from Stratford to Ebsfleet (and beyond) no problem, get triple green showing for a lot of the time

Edit: Just gone from Gravesend past Ebbsfleet - no issues either

rather strange

[AndyUK]

...I attempted to model the "Polish Train" (4Q20 Ripple Lane to Dollands Moor) so upon joining HS1 on the southbound connection, I was greeted with the red squares and emergency brakes were applied.....

....What am I doing wrong or is this a known bug?....

Have you tried starting a 395 from the same location? It appears that the TVM on the 92 does work so it may be the route isn't configured to accept a train entering HS1 at that point.

Andy L

[adam3544]

Hello everyone,
Despite the heated debates regarding the recently released class 92, I quite like it!

One thing I would like to ask though is, has anyone been successful in getting the class 92 to work properly with the TVM signalling?

I attempted to model the "Polish Train" (4Q20 Ripple Lane to Dollands Moor) so upon joining HS1 on the southbound connection, I was greeted with the red squares and emergency brakes were applied.

I thought nothing of this at first and thought it must be because I'd just joined the line but every mile or so I get the same happening and thus a brake application occuring. I was on a free roam scenario so no other trains were about but I didn't get above "80" on the TVM signalling display.

What am I doing wrong or is this a known bug?

Tom

4Q20 Ripple Lane to Dollands Moor
Where from can I get this scenario ?

Thanks.

Adam

[davidlewis]

It is just a free roam scenario that I made myself

It appears that it's just the HS1 connection lines which aren't correctly configured to allow entrance/exit of HS1. Does anyone know how to rectify this please?

[adam3544]

It is just a free roam scenario that I made myself

It appears that it's just the HS1 connection lines which aren't correctly configured to allow entrance/exit of HS1. Does anyone know how to rectify this please?

I hope and wish for this route to be extended to Dollands Moore.

[yyyyamst]

Ran a Light Engine starting from Stratford and TVM worked ok. Hopefully a fix to the Route will allow Class 92 hauled Trains to join the route and continue. The Faversham Route in the sim just is not geared up for Freight Train running as you need a start and Finnish point, not ad hoc.

[749006]

I just did a Free Roam from Ebbsfleet with the 92 and two wagons.

I pre set the point in to the sidings at Ripple Lane and it worked. The Line speed on the F3 showed 140 all the way thru the crossing but the TVM showed 130, then 80, then 60 to the last TVM board which shows 000.
I tried to go further but ran out of power as the track must not be for Electric trains.