Using a Saitek Yoke system

[ProRail]

Hi guys,

I tried to install the Railworks Yoystick API and set some controls to my Flight Yoke.
Setting the controls works well.

Then I start TS2014. Load up a scenario for the class 90 and when it is time to go the brakes won't release. I do that with the mouse. Then I push the throttle (on the yoke) and the big thing starts to move.... But only for 2 seconds. After that the API is apparently crashing and nothing works.

Any suggestions?

[749006]

Which version of the Class 90 are you trying to drive?
In theory the RSC Class 90(HUD) works with the x-box so should work with the Yoke.

[749006]

Which version of the Class 90 are you trying to drive?
In theory the RSC Class 90(HUD) works with the x-box so should work with the Yoke.

Just checked the manual and you cannot use the x-box controller on the ADV version so I suspect the Yoke won't work.
The HUD version does support the x-box controller.

Peter