Flashing screen

[grahnewell55]

Hi,

Need some help/Ideas please. I made a scenario yesterday which worked fine. However today when I go to the cab view(voyager) all I can see are flashing coloured shapes!
If I go to another view its fine! However when I scroll around a bit the same happens anywhere in the scenario. All other scenarios are fine, and so is the voyager. Is this just a case of the scenario being corrupt or am I missing something? I have attached a screenshot if it helps, but I doubt it!!

Thanks

[firetrap1]

Have you tried to edit or replace the voyager .bin files per chance? I see this sometimes when I have made a mistake during reskinning.

Where did you get the voyager from? Have you downloaded an update to the train recently?

Chris

[grahnewell55]

I removed and re-installed all voyager files and still the same. Only appears to be this scenario! If I go into edit and fly to a different location I tend to get the same it happen outside the cab,I've put every voyager I have in a test scenario and all is fine!!!

[Darpor]

What route is it on?

[Kariban]

And what other stock is nearby?

[grahnewell55]

Its on WCML and and there is another voyager approaching, but I dont need to be anyway near it for it to start happening

[msey0002]

I removed and re-installed all voyager files and still the same. Only appears to be this scenario! If I go into edit and fly to a different location I tend to get the same it happen outside the cab,I've put every voyager I have in a test scenario and all is fine!!!

I had this issue on every scenario featuring the Class 390, and had to do a verify cache.

Unfortunately you must do a bit of trial and error to see which stock is causing it and re-install accordingly

[firetrap1]

I bet that the fault is due to the older version of horgys class 390 reskin being incompatible with the updated class 390. However it could be a class 86 reskin or class 170 reskin at fault as well.

To solve the issue the OP should redownload the latest version of the virgin trains class 390 repaint and see if that sorts the problem.

Chris

[grahnewell55]

390 was the problem, all working fine again now...Thanks all of you for help and suggestions

[firetrap1]

390 was the problem, all working fine again now...Thanks all of you for help and suggestions

Good news! Glad to help.

chris