Trigger Instructions

[Kevin99]

Hello All,

I do not understand trigger instructions and they are sending me bonkers. I cannot find any information about these at all. I have set up an instruction 30 seconds after the start of my scenario this works Ok. When I add another, I assumed it would work say 5 minutes into the scenario and give me another message I set the time at 5 minutes and I came up at 5:30 so I assumed that it should be 4:30 after the first message it came up at 7:34 after the start of the scenario. Also it seems to make a difference as to where the trigger points are placed in the list.

Can anyone advise as to how this is to work?


Thanks Kevin99

[FoggyMorning]

The timing relates to the last instruction in the work order. So for example if you have a station stop at 8 minutes into the scenario and want a trigger instruction ten minutes in, the time you enter will be +02:00. Note that waypoints (the red flag) are not considered "full" instructions so these should be disregarded when working out trigger instructions

Hope this helps