Can't get 4 SUB to move

jimmychoo · Post by **jimmychoo** » Fri Jun 10, 2011 10:35 am

I've downloaded Richard's excellent 4 SUB EMU but I can't seem to get it to move. I've released the brakes (inc. handbrake), put the reverser to forward and notched the throttle at 25% but nothing happens-I just get the motor whine. I've gone over the instructions a few times but I can't see what I'm doing wrong. Could anybody assist please?

alexnick · Post by **alexnick** » Fri Jun 10, 2011 10:48 am

Are you running it with simple controls on? The more scripted RW models sometimes don't like that.

Otherwise what your doing sounds OK.

AN

class43HS125 · Post by **class43HS125** » Fri Jun 10, 2011 11:31 am

Hi,
I know this is basic and fundamental but you do have it sitting on Electric track?
been there done that, ended up having to get a diesel to tow the consist away.
Was more fun that just deleting it

Ross
NZ

jimmychoo · Post by **jimmychoo** » Fri Jun 10, 2011 2:04 pm

I have Expert mode on, but I have to admit I have it on a non electrified siding at the moment to try it out without realising it - DOH! I'll give it a try tonight and see what happens.

SHEEP · Post by **SHEEP** » Fri Jun 10, 2011 9:04 pm

jimmychoo wrote:I have Expert mode on, but I have to admit I have it on a non electrified siding at the moment to try it out without realising it - DOH! I'll give it a try tonight and see what happens.

Don't forget the Deadmans handle (press "A" before moving the Reverser)
I did

jimmychoo · Post by **jimmychoo** » Sat Jun 11, 2011 10:09 am

Thanks very much for your help guys. The problem was not being on electric track. I put it on the Leafy Suburbs route and it works fine now. How embarrasing!

Atomic Systems

Can't get 4 SUB to move

Can't get 4 SUB to move

Re: Can't get 4 SUB to move

Re: Can't get 4 SUB to move

Re: Can't get 4 SUB to move

Re: Can't get 4 SUB to move

Re: Can't get 4 SUB to move