Hi all,
Just bought the JT A4 pacifics pack, and am having trouble with the controls, the injectors dont respond to keyboard commands, along with the Dampers, the blower seems temperamental as it only works sometimes.
Is this a known issue?
Rob
A4 Pacific Control Problem
Moderator: Moderators
-
RobertM
- Very Active Forum Member
- Posts: 5907
- Joined: Thu Aug 12, 2004 5:28 pm
- Location: Centre of my own universe, where its scary
A4 Pacific Control Problem
Cheers, Robert 
Fireman at the Lakeside & Haverthwaite Steam Railway.
Second Valve simulation - https://www.facebook.com/secondvalve?ref=hl
Fireman at the Lakeside & Haverthwaite Steam Railway.
Second Valve simulation - https://www.facebook.com/secondvalve?ref=hl
Re: A4 Pacific Control Problem
Have you checked you have got auto fireman off and are in expert mode
Edward
Edward
-
RobertM
- Very Active Forum Member
- Posts: 5907
- Joined: Thu Aug 12, 2004 5:28 pm
- Location: Centre of my own universe, where its scary
Re: A4 Pacific Control Problem
It is expert and manual fireman is on
Cheers, Robert
Fireman at the Lakeside & Haverthwaite Steam Railway.
Second Valve simulation - https://www.facebook.com/secondvalve?ref=hl
Fireman at the Lakeside & Haverthwaite Steam Railway.
Second Valve simulation - https://www.facebook.com/secondvalve?ref=hl
Re: A4 Pacific Control Problem
Hi
Read input mappers thread
Phill
Read input mappers thread
Phill
Re: A4 Pacific Control Problem
Hi Rob
I've updated verything on my RW installation and controls all seem to work ok for me with mouse and keyboard commands... Injectors respond to I and O keys, Dampers to M / shift + M, Blower to N / Shift + N, small ejector to J. Nothing visual happens with the K / shift + K and L / shift + L keys that increase injector water rate. (see page 17 of drivers manual if you havent already seen the bit about expert driver commands). If you are still having problems then I suggest you let Just Trains Support know and give them as much info as you can about your problem and your hardware setup / OS etc.
KR Matt
I've updated verything on my RW installation and controls all seem to work ok for me with mouse and keyboard commands... Injectors respond to I and O keys, Dampers to M / shift + M, Blower to N / Shift + N, small ejector to J. Nothing visual happens with the K / shift + K and L / shift + L keys that increase injector water rate. (see page 17 of drivers manual if you havent already seen the bit about expert driver commands). If you are still having problems then I suggest you let Just Trains Support know and give them as much info as you can about your problem and your hardware setup / OS etc.
KR Matt
Re: A4 Pacific Control Problem
If you've got the IHH Breakdown Crane installed that might be the reason, it seemed to be in my case - see this thread: http://forums.uktrainsim.com/viewtopic. ... 4&t=108071
Andy L
Andy L