Atomic Systems

Had a look on the tutorials page about swapping catenary, noticed there was one about removing it but what I would like to know is how can I swap out the catenary used in the Albula v2.b route for Thomsons Albula one? Is it even possible... Also Signals, I'm guessing that is a whole different kettle of fish?

smarty2 wrote:Had a look on the tutorials page about swapping catenary, noticed there was one about removing it but what I would like to know is how can I swap out the catenary used in the Albula v2.b route for Thomsons Albula one? Is it even possible... Also Signals, I'm guessing that is a whole different kettle of fish?

Yes. The process would be the same for swapping track or indeed any asset. The tutorial on swapping track will help you.

Catenary swapping might be possible, but would depend upon them being exactly the same size and height as the ones you were replacing. Try swapping a few on a clone of your route?

As for signals, I doubt if this is possible as you would need to swap exactly the right type for each junction.

Thanks Mike, think I will leave it to the professionals!