End of scenario issue

[delsutton]

Hi

I've made quite a few scenarios at this stage and never come across this issue before.

I've spent a bit of time constructing a new scenario and just tested it fully a few times. I've got a final instruction to head to a siding and slotted in that same siding as the final destination as well. The trouble is I never get the sliding red bar showing the time until the task is completed and the end message never shows.

I've tried a number of different locations but none works. Everything else works and no sign of any conflicts etc. Anyone got a clue as to what is going on here?

Del

[jp92214]

Del.
Are you testing from editor? I've found that various odd things can happen if you do. I always test from the drive section.

What is the last instruction you are using immediately before the final destination? It should be a "stop at". I don't think anything else will show.

John.

[delsutton]

John, I've tried both from within editor and drive and both the same result. And yes, there is a "stop at" which is the same location as the final destination, so, in theory it should be fine

[jp92214]

Del.
What route is your scenario on and what siding is the final destination. If I have the route I'll have a play around in editor and see what happens if you want.

John.

[delsutton]

Hi John. It's the ECML London-Peterborough one. The destination I'm really trying to end at is Fletton Siding, about 1.5 miles south of Peterborough station. I've made scenarios on that route before and never had a problem. I've also tried a few of the sidings north of the station and having the same issue

[jp92214]

Hi Del.
I've just done a short test on this route into the same siding and had no problem. One thing I did notice, when I shut down editor and it goes to play, the signals were wrong. So I went to drive, standard and signals OK. Following instructions given.

Start. Fletton Dn Rev. (Just south of the siding)
Stop at, Fletton Dn Slow Rev. (10 secs)
Stop at, Fletton siding (10 sec) Pop up message appeared OK.
Final dest. Fletton siding.

If yours is not doing it then can I suggest you clear the in game cache and try again, after double checking your timetabling.

John.

[delsutton]

John

Thanks for the feedback. Have been a bit busy over the last couple of days.

In fact, I'd set up a new scenario as a test as well and no problems either. Cleared the cache as you suggested and no change. Then I deleted my train in the scenario with an issue, set that train up again and it works! Must have been some bug somewhere but still don't understand it

Thanks for your help
Del