Siding Markers
Posted: Tue Apr 23, 2013 6:06 pm
I am just curious to the behaviour of TS2013 sometimes. As background, please read the following posts:
http://www.trainsim.com/vbts/showthread ... fill-point
http://forums.uktrainsim.com/viewtopic. ... a#p1636083
In the end I did manage to get it right with the help of John.
Now I am busy creating a new scenario. It is not necessary to give the name of the route as this happened to me before on other routes also.
I put a siding marker on a track in a yard. Then I give the driver instructions to drive to a certain point. He must cross this siding marker, but I do not use it in the instruction yet. Now after he has finished whatever task, I route him to another point and give this siding marker as a via point. Immediately the whole Driver Instruction box gets that ugly red marks. Now previously I altered the scenario until the timetable is normal again.
After I struggled with the Water refill scenario, it suddenly striked me. I saved the scenario, with this ugly red marks, close TS2013 and fired it up again. All of a sudden everything is fine.
Further down the line, I put a siding marker at which point I want to give an instruction to the driver and again this ugly red stripes. Again I followed the advice of John and it worked again.
Now, why does this happened sometimes and other times you can route over siding markers as you wish and no ugly red stripes?
Regards
http://www.trainsim.com/vbts/showthread ... fill-point
http://forums.uktrainsim.com/viewtopic. ... a#p1636083
In the end I did manage to get it right with the help of John.
Now I am busy creating a new scenario. It is not necessary to give the name of the route as this happened to me before on other routes also.
I put a siding marker on a track in a yard. Then I give the driver instructions to drive to a certain point. He must cross this siding marker, but I do not use it in the instruction yet. Now after he has finished whatever task, I route him to another point and give this siding marker as a via point. Immediately the whole Driver Instruction box gets that ugly red marks. Now previously I altered the scenario until the timetable is normal again.
After I struggled with the Water refill scenario, it suddenly striked me. I saved the scenario, with this ugly red marks, close TS2013 and fired it up again. All of a sudden everything is fine.
Further down the line, I put a siding marker at which point I want to give an instruction to the driver and again this ugly red stripes. Again I followed the advice of John and it worked again.
Now, why does this happened sometimes and other times you can route over siding markers as you wish and no ugly red stripes?
Regards