Atomic Systems

Hi alll

My junctions are not behaving properly! Railworks is refusing to render the points properly even on a flat gradient with parallel tracks, and the weld tool has no effect. It won't work with either the crossover tool or using snap to track.
Can anybody advise please?

Thanks,

T3R

Hi,

It's a common fault with rail works. Quite a common technique is to lay the junction as you have, then usin the split tool, create a split in the middle of the junction, and then weld the two prices together again.

Thanks

Ian

Ian, thanks I'll give that a try later.

Regards,

|T3R||

Ian that worked brilliantly, many thanks!