Atomic Systems

I've had one or two scenarios lately where before I even get started a message pops up locomotive ran out of fuel. Why does this happen on DMU's? Is there any way I can correct the situation?
Thanks Dumps

Go in to the Scenario Editor and double click on each DMU

A Fuel Gauge will pop up and you can move the slider to 100%

Thank you Peter for that information. I've been looking and looking for the Scenario Editor but as yet can't find it!! Could you point me in the right direction please that would be most helpful. I tend to use TS Tools for my alterations. I'm mostly off line when playing the game.
Thanks Dumps

Go in to Build > Scenarios then pick the route and a list of different scenarios appear.

Find the one with the problem then Highlight it and click Edit in the bottom right

Or run the specific scenario as normal then press Ctrl + E and it will load you in to the editor, you then need to click on the scenario editor icon (top left slide out window furthest icon to the right) and wait for it to reload.

Then you can follow Peters instructions to add fuel.

Thanks for all your help.
Dumps