Atomic Systems

Hi all. Can anybody please tell me how to scroll the destination blind on the 150/1 please? I can't for the life of me work out how to do it, and there is no info in the manual.

Cheers all
Terrone.

Ctrl+Shift+5, and Ctrl+Shift+6

Thanks buddy, I tried all sorts of key combinations and brought up stuff that I had never seen in TS before

Cheers
Terrone.

I did not know you could change destinations in the way described above. I have only managed to change destinations in the Class 350 LM by using the in cab button. Lots of classes seem to have similar devices portrayed but are not active! Are there any other trains using this system which are active?
Thanks
Dumps

Class 156 definitely does, maybe not the same keys though.

JT's Class 153 (using CTRL+F12 and SHIFT+CTRL+F12)

Isn't it easier to use a single key press, F8 scrolls up and F7 scrolls down, when you zoom up close to destination window on the front of the loco? (Class 150).

It would if it worked!

(and where have you seen that?)

brummie wrote:Isn't it easier to use a single key press, F8 scrolls up and F7 scrolls down, when you zoom up close to destination window on the front of the loco? (Class 150).

chrisonline wrote:It would if it worked!

(and where have you seen that?)

Possibly on Thomson's 150/2 model.......

Hi gptech,

That is the one I was referring to! (Thompson). Didn't realize this was about another one.

brummie wrote:Didn't realize this was about another one.

You read DTG as Thomson???

Senior moment......