Page 6 of 6
Re: BR (LNER) Peppercorn K1 Released!
Posted: Sat Oct 31, 2015 8:17 am
by tnleeuw01
Trev123 wrote:In the scenario March Surprise after dropping off the gas tank wagon at the siding, you cannot get clearance (Tab Key) to pass the red shunting signal while backing up to the guards van and get a SPAD game over error.
You're backing up to the van - meaning you'd need ctrl-tab to get clearance?
Also, you're sure that any switches are in correct position?
I haven't yet tried the scenario so I have no idea, but just some suggestions!
--Tim
Re: BR (LNER) Peppercorn K1 Released!
Posted: Sat Oct 31, 2015 8:35 am
by Trev123
Thanks that did the trick. You forget about key commands that you don't use very often, although I think in the past getting clearance to reverse past signals has worked with just the tab key.
Re: BR (LNER) Peppercorn K1 Released!
Posted: Sat Oct 31, 2015 9:29 am
by tnleeuw01
Trev123 wrote:Thanks that did the trick. You forget about key commands that you don't use very often, although I think in the past getting clearance to reverse past signals has worked with just the tab key.
It always required a separate key, although in the past it used to be shift-tab, before the Steam-overlay in-game was introduced.
--Tim
Re: BR (LNER) Peppercorn K1 Released!
Posted: Mon Nov 02, 2015 8:24 am
by kirkheath
It always required a separate key, although in the past it used to be shift-tab, before the Steam-overlay in-game was introduced.
--Tim
As Tim said, there were two separate commands.
TAB was right too, if the signal needing permission was ahead of the train/engine. Whilst, if it was behind the train/engine you would need the command Tim mentioned. I re-programmed either the command or the steam overlay to Ctrl+ Tab to, stop them both being used at the same time.
Re: BR (LNER) Peppercorn K1 Released!
Posted: Mon Nov 02, 2015 11:22 pm
by Trev123
The scenario March Surprise really is a surprise as you don't know how well you are doing against the clock for about the 3 last waypoints until you have filled the loco up with water and then you have to move about 50ft to the station and stop, then the scenario ends.
Re: BR (LNER) Peppercorn K1 Released!
Posted: Tue Nov 03, 2015 9:32 pm
by Trev123
New update. Wondered what my 98mb update was for the other day.
http://www.engine-driver.com/article/sh ... -scenarios
Re: BR (LNER) Peppercorn K1 Released!
Posted: Tue Nov 03, 2015 11:37 pm
by tnleeuw01
That's the update from last week, mentioned earlier in the thread...