Page 1 of 1
Does anyone have any idea what causes this ?
Posted: Sun Sep 06, 2015 8:52 pm
by ka959
When a fenceline, which should be STRAIGHT, arches upwards, from it's start-point, to it's end-point, and needs to be removed, and re-laid, before being done correctly ? The fence is still perfectly straight, before it rises upwards, at about roughly 40/45 degrees angle. How do you stop it doing this, if it's happened to you, before ?
Regards...
Jim Mcdermott
Re: Does anyone have any idea what causes this ?
Posted: Sun Sep 06, 2015 11:05 pm
by Halbers
Hi Jim,
Have you accidentally pressed the "snap to terrain" button ? If so, turn it off and it should be fine.
Check that the loft gradient is set at zero and you will get a horizontal fence.
Steve
Re: Does anyone have any idea what causes this ?
Posted: Sun Sep 06, 2015 11:57 pm
by ka959
Hi mate...
That's worth a try, and I had a look at my screen all over, and I think this same thing actually happened to me in the distant past, but it seems I had forgotten what the fix for this was. It was very rare, but I do recall it. I got help, and it worked, then. I think i must have accidentally pressed something I didn't intend to, by mistake, but will need to remember thid, next time, if I can !
Regards...
Jim McDermott