Atomic Systems

... and I'm testing imminently!

http://digitaltraction.co.uk/mainsite/

I got my pre-order email link this am.

Won't be able to download until tonight, but keen to see how it performs

Just downloaded my pre order model,off to test later today
Mike

Just been for a quick test run, it's certainly brilliant. Superb addition to my fleet.

Many thanks DT!

Nick

Hope to test this on my "Big Hill" tonight

My only problem which I have reported to them of Facebook is that I am unable to couple/uncouple boiler first without a derailment and stock flying about.

Anybody else have this issue?

Nick

Im getting jet black Smoke and Steam from the whistle and cylinder cocks!

niclouse3 wrote:My only problem which I have reported to them of Facebook is that I am unable to couple/uncouple boiler first without a derailment and stock flying about.

Anybody else have this issue?

Nick

I think there's a collision dimension error, like the width of the Dovetail 220. Only other thing I've heard of is there being one white digit on the bufferbeam.

Hello has anyone else had problems with this loco,I cant get simple controls to work but it works with all other locos,and cannot couple to anything else with the front coupling ? thank you.

I have tried both the BR Black Lined and The GWR Lined Green versions,every thing seems to work OK except after setting off, if I take regulator over 35% the revercer shoots up to 78% and stays there,until I bring the regulator back down to 33%, then I can use the revercer again.
Cylinder and Whistle are white for me.

Its probably me doing some thing wrong

Mike

michaelhendle wrote:I have tried both the BR Black Lined and The GWR Lined Green versions,every thing seems to work OK except after setting off, if I take regulator over 35% the revercer shoots up to 78% and stays there,until I bring the regulator back down to 33%, then I can use the revercer again.
Cylinder and Whistle are white for me.

Its probably me doing some thing wrong

Mike

Reverser lock? Press E.

Hi
How I start off, Press E, press J, press H,

Release Train Brake move revercer to about 60%, move regulator forward when train gets to about 15 mph press J key again,

Slowly increase regulator and decrease revercer,then when regulator gets above 35% the revercer shoots up to 78% and stays there,until I bring the regulator back down 33% then the revercer works again.

Mike

Hi Mike, you need to alter the reverser then press E again to lock it. then E again to adjust then E to lock.

bigmull wrote:Im getting jet black Smoke and Steam from the whistle and cylinder cocks!

I'm getting the same from the DTG "Sir Lamiel", since last upgrade...

Could someone put some cab photo's on here, haven't seen any yet.

Anthony