Atomic Systems

Is there anything wrong with Workshop ? I just got on it this morning, and nothing appeared to be wrong with it on first look, but as I did the normal things I usually do with it, first of all, the thing you place a tick on, wasn't showing at all. So I clicked the picture, to enlarge it, and show the green part, to make the "selected" part show, and hopefully, the "tick" on the smaller green square show, when I brought up the normal-sized picture, but, no luck at all. Has this happened to you, at all ?

Regards...

Jim McDermott

Steam is a bit slow at the moment Jim. Was downloading a 10mb update and it kept timing out. Speed was down to about dialup speeds. Had to switch to offline mode to run TS.