Atomic Systems

I was doing a little work on my computer, and with the Workshop, and noticed that the "Drive" button wasn't showing at all. I had finished re-downloading TS2015, due to problems with the Workshop items causing starting problems with getting the game running at all. Now it's running perfectly, and now I'm happy it's back to normal - or is it ? I hadn't finished configuring it, with the "Settings" button, I THINK ! The "DRIVE" button didn't show at all. Is it suppose to show, or what ? Is something supposed to turn it on, or was something done to archieve this, when you turn your computer on one morning, in the past ? Can I do anything to get it back, again ?

Regards...

Jim McDermott

I was intrigued by the title and a little disappointed when I read the content.

Regards,

Len

I'm more than a little disappointed that a constructive answer couldn't have been given.


Jim, do you mean the 'Play' button whilst in the Workshop or in the game itself?

You don't have to do anything to make any menu buttons show up, so just what do you see when the game fully loads?

The drive button in the workshop screen is sometimes blanked out when you select some scenarios, don't know why, cause if I go to the route for that scenario I can drive it from there.

To The OP
I echo what Trev123 says in some cases for some WS Scenarios under "Profile" etc, the "drive" button does not appear - at first I thought that it was due to say missing re-skins, but like Trev says if you go to the route under "drive" the scenario loads fine with nothing apparently missing.

It could be worth raising with DTG on their new support system, to see if they have an answer (it may have already been raised and discussed), or it could be some STEAM glitch.

I for one, would be interested to know the answer to this one.

pH