Atomic Systems

These are now available from:

http://www.steamsoundssupreme.com/page_rsp.html

Used my discount code, an utter bargain at £2.80 .

Thanks eyore and SSS for making these available,

Cheers,

You're welcome! Make sure you try the scenario's. A fantastic pair of scenario's created by UKTS' very own Rosgar.............................

Regards
Matt@SteamSoundsSupreme

Purchased and will be able to try tomorrow night - cannot wait!

Quick question, what does the term 'departmental' mean? Did they belong to a certain department or what?

Civil engineer's department, as opposed to revenue earning

Anyone got the scenarios to run? Unfortunately like the scenario for the RLP thses won't run even though I have all the stock.

No joy...

Marcus

I Have no problems at all with both these Scenarios for WSOL

Are you sure you have installed all 3 included rwp's correctly.

These are :-
Departmental Hopper Pack Version1.rwp
Fix Now Lift Later Part 1 (Diesel)
Fix Now Lift Later Part 2 (Steam)

Regards

Mike

Well all the stock and both scenarios are there so not sure what else there is to check. Will install again but as all present and nothing missing obviously something like too many assets I guess.

Same here. RWTools gives both scenario's the all clear, but Railworks crashes on loading (both scenario's )..

Marcus

Well at least it is not just me. Whilst TS2014 massively more reliable now I still get some scenarios that just do not load at all. Never mind.

The RLP scenario fails for me but these two work fine. I had to swap the EE Type 4 to the DT version but, apart from that, no problem at all.

Keith

I installed only Part 2 since I don't have all of the stock for Part 1. Part 2 checks out fine with RW_Tools but produces a dump file when I try to run it.

chrisrichards wrote:I installed only Part 2 since I don't have all of the stock for Part 1. Part 2 checks out fine with RW_Tools but produces a dump file when I try to run it.

chrisreb wrote:Well all the stock and both scenarios are there so not sure what else there is to check. Will install again but as all present and nothing missing obviously something like too many assets I guess.

The asset list for these is actually quite short.
However due to the Stanier 8F being part of the Woodhead route then maybe that makes the available memory resources a little thin for some, as of course WLOS is in itself memory intensive.
Other than the standard advice to clear your cache, and maybe set your graphic settings a tad lower, there is no good reason why these scenarios shouldn't run as intended, which for most users do appear to work without issues.

Thanks for the suggestion.

I turned down the Scenery Quality from Highest to High and turned off Headlight Flares.

Part 2 now starts for me, as does the SSS RLP scenario which I couldn't run before.