Atomic Systems

Good afternoon everyone
Today I purchased the Southern Pacific GP20 Locomotive
When I go to the collection screen the loco is displayed however if I try to select it nothing happens?
Normally selecting a loco from the collection lists routes where the loco can be found/used
I've tried validating TS2014 but to no avail
Any suggestions would be appreciated as it is clearly something and nothing
I purchased Horseshoe Curve earlier today and that is perfectly fine
Kind regards Stephen

Where did you purchase the GP25?

I have seen a Southern Pacific GP20 which comes with Scenarios for Donner Pass
http://store.steampowered.com/app/222571/

Sorry about that I mean't GP20
I have Donnor Pass on my computer
http://store.steampowered.com/app/222571/
Kind regards Stephen

As you can see in the Manual what the Scenarios are called have you checked in the Editor [Build] to see if the are there?

Also the loco has Quick Drive so do a run over one of your routes to check it's working.

Peter

Thanks Peter
I just had a look in Drive and sure enough the loco was listed and can be used
Kind regards Stephen

So for the last test.
Go in to the Editor, find Donner Pass, find a Scenario that the GP20 uses - click edit and when it loads click the Play button bottom right.

It might be the Scenarios are Career or Standard which means they will show up in one section and not the other.

Peter

Many thanks Peter
The loco appears in the scenario editor for Donnor Pass
Kind regards Stephen