Atomic Systems

Hi guys,

I tried to install the Railworks Yoystick API and set some controls to my Flight Yoke.
Setting the controls works well.

Then I start TS2014. Load up a scenario for the class 90 and when it is time to go the brakes won't release. I do that with the mouse. Then I push the throttle (on the yoke) and the big thing starts to move.... But only for 2 seconds. After that the API is apparently crashing and nothing works.

Any suggestions?

Which version of the Class 90 are you trying to drive?
In theory the RSC Class 90(HUD) works with the x-box so should work with the Yoke.

749006 wrote:Which version of the Class 90 are you trying to drive?
In theory the RSC Class 90(HUD) works with the x-box so should work with the Yoke.

Just checked the manual and you cannot use the x-box controller on the ADV version so I suspect the Yoke won't work.
The HUD version does support the x-box controller.

Peter