Atomic Systems

smarty2 wrote:

sargnickfury wrote:No one else having this issue?

I'll take a butchers, but in the meantime I suggest you e-mail the author.

I'll do that directly.....never heard have a "Butchers" before had to wiki and read up on Cockney and have a good giraffe...

Well I've tried it and all is functioning as expected! You aren't running a double loco set are you? Glad to have put a smile on your boat!

I am specifically running the three corners alternate scenerios.

doing this one "10A Nahverkehr nach Feldkerich"

I also confirm... I do not see any issue with the Taurus after the TS2014 update... luckily...

I'll test that scenario specifically and let you know...

I have no problem in this scenario, I had noticed the first time I fired up a scenario to try the AFB that the specific loco wouldn't load as TS couldn't locate it, after a copy and paste from a back up it worked, if you have a back up try that and give it another go.

I too see no problems with that scenario. Are you using the latest version of the Taurus?

One more thing, guys... did you notice this new repaint on rail-sim.de? Excellent job, one is weathered...

http://rail-sim.de/forum/board38-train- ... -download/

Hmmm not sure what I am doing then. It is usually after I have had to make a harder stop, where I waited longer then I should to decrease for stop so the Dynamic via AFB has gone on full. I break as well....once stopped the Dynamic is locked at 25-35% it does not disengage. Also trying to disengage it via the screen gui does not work.....it has to be done with the mouse via the cab control on screen. Afterwards the dynamic may or may not kick in once restarted..... I may just reinstall.

Just wondering, I do not update this regularly only checking every once in a while . I notice as of todays date the last update was posted Nov 7, and I can't remember if this is applied. Does the latest updates include all changes made in the previous updates ?

Antony

Ajay1 wrote:Just wondering, I do not update this regularly only checking every once in a while . I notice as of todays date the last update was posted Nov 7, and I can't remember if this is applied. Does the latest updates include all changes made in the previous updates ?

Antony

i would think so - what does it say on the Website?

Hello sir,

If you run the HRQ installer what it actually does is synchronisation of files. Therefore once it completes and says that "All files downloaded successfully" it means you have the most up-to-date version no matter how long it's been since you ran it last time. It is very similar to Steam verification.

Additionally some smaller updates or fixes are often distributed without any announcement at all so it makes sense to run the procedure every now and then.