Atomic Systems

Hi all,
It would seem to me that if route builders could build their routes in a clean version of railworks it might stop SBHH happening
with some routes and cannot run them (ie:- For me personnally Ferrovia sul confine Ver 3.1 and South West Wales ver 3 )
I know it would be a little strange to prepair an asset list before starting a route but it seems to me that is exactly what the
payware route builders must do to ensure nothing is saved with the route when completed that will cause it to SBHH.
I know senarios can be a problem for all routes (SBHH) but I do not know of any payware route that has not run first time because of SBHH, unless the main program has been corrupted by an add on asset( or missing assets which can generally be fixed with RW-Tools)) and after a veryify they general run again.
They are some odd things happing and it can only be down to the way the program saves and installs 3rd party routes,senarios and assets.
Best of luck to all
Stan

Stan,

Have a read of the thread "Problems with 3rd party routes in TS2013 with SBHH".

Bob.

Hi

The Ferrovaria route runs for me but in a separate asset set. SWW will load and start but keeps crashing in same area which probably means soe issue on a tile that needs fixing for TS2013 but that the previous version could cope with.