Page 1 of 1

DT Mk1 BFK and BSK

Posted: Fri Oct 12, 2012 9:35 pm
by RONVKING
Hi,

I have the complete DT Mk1's but cant get the BSK and BFK coaches to appear when making a consist. The other coaches show OK and a reinstall didn't make any difference nor did clearing caches etc.

The silly thing is that they appear to be there because if you select them and go to place them between other wagon/coaches these move across leaving a space.

It does not make a difference as to what region these are so clearly its something affecting these coaches in general rather than just one or two.

Any suggestions please, have place a note on DT FB page as well.

Cheers Ron

Re: DT Mk1 BFK and BSK

Posted: Fri Oct 12, 2012 9:38 pm
by gptech
Make sure the Kuju/Railsimulator asset provider boxes are ticked in the scenario you're trying to place the coaches in---the coaches reference the default couplings so these boxes need to be enabled.

Re: DT Mk1 BFK and BSK

Posted: Fri Oct 12, 2012 10:40 pm
by RONVKING
They were ticked. As mentioned in my first post the other coaches in the same DT collection workand are visable so if it was an unticked asset I would have expected none of them to work.

Also just tried making a consist with one of these invisable coaches and sure enough It gets acepted and I end up with a rake of coaches with an gap where the BFK was place but it runs.

Re: DT Mk1 BFK and BSK

Posted: Fri Oct 12, 2012 11:24 pm
by gptech
Next thing to check is whether you actually have the .GeoPcDx files in the right folders----bit of a long shot but I've managed to move files about without trying before! :oops:

Re: DT Mk1 BFK and BCK

Posted: Sat Oct 13, 2012 4:22 am
by RONVKING
That was the first thing I checked.

I'm beginning to think its a TS2013 issue as I just tried installing DT's first edition Mk1's and the same thing has happened in that some stock shows and others don't.

I also checked, found and removed, a few 0 byte files bit that didn't change the issue and on looking at the original files they were there anyway and the stock worked OK IN TS2012, in fact tried copying from my TS2012 backup and still no change.

Seems strange that in all intents and purposes these files are present as you can select them of the menus and put them in a consist, most errors would cause a SBHH at that stage. It just that you cannot see a single piece of the coach. Might have to ring Hogwarts and get the invisable spell reversed.

Oh and just noticed a slight cockup. The coaches are in fact the BCK's and BFK's that are not playing. The BSK's are from the LP pack and are OK.

Thanks gptech for your thoughts so far.

Cheers Ron

Re: DT Mk1 BFK and BSK

Posted: Sat Oct 13, 2012 5:23 am
by BobLatimer
Not sure that this helps Ron, but I've just placed all variants of the DT Mk1s on my test track and they all show up intact.

Bob.

Re: DT Mk1 BFK and BSK

Posted: Sat Oct 13, 2012 9:03 am
by gptech
Just for fun, cut the 'textures' folder for one of the missing items out of the game and on to your desktop. Try placing that coach and see if it 'jump starts' the game into displaying the 'missing texture' flags around where the coach should be.
Just like Bob, I've been able to see all the variants too which whilst not helping you does suggest that the stock is in fact OK and the problem is a local one.

Gary

Re: DT Mk1 BFK and BSK

Posted: Sat Oct 13, 2012 9:25 am
by RONVKING
Thanks Gary,

I'll try that later today. I'm going to try another verify as well as noticed I can't see my class 153's and other stuff I had not tried after the changeover appears a little strange.

Thanks Ron