Atomic Systems

hi all,
i am currently making some scenarios for my route, but after adding the driver symbol and pick up passengers. when i click on a platform marker to show what particular stations i want to stop at a board on the side of the screen has 3 exclamation marks. next to it in red this is a standard scenario and it says cannot find the station if i run the activity.
what can i do.
pingmaster

Have you perhaps made a mistake with setting up a path following track set only in the opposite direction, or with a gap in electrification or a freight-only line?

You will be able to find out more information about what is going on by using the timetable mode screen, which you can activate by pressing the little clock icon in the top-left flyout. There you can view messages which should give you some clue as to the cause of the issue, and make changed like adding waypoints (red flag icon) to help make sure the desired route is used properly.

many thanks i haven't electrified all the track will that be why.

many thanks

pingmaster wrote:many thanks i haven't electrified all the track will that be why.

many thanks

Quick way to check if that is the only issue - try it with a diesel. If it still doesn't work then you may have other issues to sort out.

hello again another problem with a scenarios i have finished a route of the outer london line and i am making a activity from streatham to victoria but when i use a pick up passenger sign there are red explanation marks in the corner of the box i have tried it with a diesel and it works
so what can i do

pingmaster wrote:hello again another problem with a scenarios i have finished a route of the outer london line and i am making a activity from streatham to victoria but when i use a pick up passenger sign there are red explanation marks in the corner of the box i have tried it with a diesel and it works
so what can i do

pingmaster wrote:many thanks i haven't electrified all the track will that be why.

many thanks

I'd suggest you check through your track again, it's a fair bet you've missed a section when electifying it.

But I used the bml track and track rule With the 3rd rail

But did you check in every track laying sequence that nothing had gone amiss?
But have you checked it since?

What you did and what you're getting are two seperate things, the most logical explanation is that a section is 'dead' so applying Occams Razor suggests you check this first.