Atomic Systems

hi there just got Railworks WCML north route and it runs ok on free roam but when i goto any senareos i get a message that something seriously wrong run diagnostic and save dump file.

i have cleared the carche and deleted the blueprints.pak files but still get the same problem.

does this happen on every scenario or just the one?

your settings might be up too high... lots of people have had this issue solved by lowering the scenery detail level and turning off procedural flora. this route does need lots of computing power to get it going on full detail.

chris

I had similar problems and cured it by switching all graphics options to medium, turning off shadows and adjusting the main slider to 7.
Worked fine then. The main thing I noticed was losing a small number of catenary masts, the route remained very enjoyable and there's still lots to see (including all those buses!).

Simon Spoerer

will try that.