Starting location in free roam scenario

[jalmar]

Hi,

I made a freeroam scenario for Hagen Siegen. It starts at Finnentrop.
Before the update however I could use the compass flyout with it's list of other locations and then fly to the location I wanted , ie Siegen or Hagen.

Now we do not have the compass anymore.
I tried to clone the scenario and then change the starting loaction. But that's just a name, RW does not really start there.

Does anyone have an idea how to solve this ?


Albert

[nsupersonic]

Hi,

The compass is still active in the World Editor as before, please note it is now nearly transparent in nature (the bit that normally shows ) - but in the same position as before


another thought:-
If you start a scenario and wish to change location before selecting a locomotive, you could go to the edit mode change location and re-enter gameplay that way

Hope this helps

Charles

edit - The compass however has gone from the ' drive / play' mode of Railworks2 and was not really needed; as you could only sucessfully change/ jump to location in the EDIT mode anyway.

[alanch]

- The compass however has gone from the ' drive / play' mode of Railworks2 and was not really needed; as you could only sucessfully change/ jump to location in the EDIT mode anyway.

The compass was very useful in drive mode - it could be used to note locations where there were problems/errors in routes or scenarios. Now that is impossible. The loss of the compass in drive mode is a retrograde step.

[jalmar]

thx for your anwers