Atomic Systems

Hello All,

I do not understand trigger instructions and they are sending me bonkers. I cannot find any information about these at all. I have set up an instruction 30 seconds after the start of my scenario this works Ok. When I add another, I assumed it would work say 5 minutes into the scenario and give me another message I set the time at 5 minutes and I came up at 5:30 so I assumed that it should be 4:30 after the first message it came up at 7:34 after the start of the scenario. Also it seems to make a difference as to where the trigger points are placed in the list.

Can anyone advise as to how this is to work?


Thanks Kevin99

The timing relates to the last instruction in the work order. So for example if you have a station stop at 8 minutes into the scenario and want a trigger instruction ten minutes in, the time you enter will be +02:00. Note that waypoints (the red flag) are not considered "full" instructions so these should be disregarded when working out trigger instructions

Hope this helps