Atomic Systems

Hello All, Just started to build scenarios for my route testing and seem to be stuck on how to pick up Passengers. I have set up a run stopping at various stations using the pick up passenger instruction. I have arrived on time and left on time. At the end of the run the report says 8 stations passed 0 passengers picked up.

I cannot find any information on this, can sombody point me in the right direction.

Thanks

Kevin

Did you press T to open the doors?

AndiS wrote:Did you press T to open the doors?

And in RailWorks 2 if you run your cursor over the platform and the walking man icon appears, clicking the mouse at that point should also open the doors.

Hello,

Thanks for the two replies, not tried either I'm sure that both will fix it.

Thanks again,

Kevin99