Two Questions

[Kevin99]

Hello All, Just writing some scenarios for my route and have two questions.

1.) I have to use destination markers to ensure that the consists go to the right places as the despatcher send these by various routes which are not wanted. All seems to be Ok routing however the system expects me to stop at each point and registers a fault when you do not. Is this the correct procedure if not what do I do?

2.) I have notice a red triangle with a wheel in the centre which seems to have break shoes on it. I have looked around for the meaning but have drawn a blank. Any help?

Thanks

Kevin99

[skiddaw]

Hi,

When you set up the waypoints which define the exact route you want the train to follow you can set the speed the train passes through the waypoint. The default is Omph so you need to change this to some other value. It is in the RH flyout window a couple of lines below the box where you input the name of the marker/waypoint .

If the red triangle appears when you are driving then it is a warning - the one you describe is probably " wheelslip".

Hope this helps.

[Kevin99]

Hello

Thanks for the help, All the best


Regards
Kevin 99