Atomic Systems

Morning,

When I lay track, the overhead wires aren't showing up. I've changed the track properties flyout to Overhead Wires but no joy. This used to be the way to do it - has anything changed or am I missing something?

Doesn't matter which track I use either, same problem

Ant

Which track rule are you using? Not all of them have any overhead wires associated with them in the blueprint

I tried Bath-Temple (which I've used before with no problems) and WCML North as a test - with the same results. The route template is from WCML North

Thanks
Ant

Try turning your graphics settings up. I vaguely recall the OHLE disappearing on my laptop if I turned down the graphics settings. Weird when I was driving the WCML north without wires haha.