Point Levers

[johnrossetti]

Hi. Is it possible to add a point lever without re-laying the track ? There are some yards that never had them and I would like to add some. Thanks

[antonyperks]

Yes what you must do is go to the track panel at the top, click on the split tool, which is the second one, the hover the mouse pointer over the triangle where the point starts then left click, This will break the point, Now make sure that the lever icon has the little dot at the bottom below the gradient box, Now click on the weld button again at the top- the circle with a right angle through it, and the point should now render with a lever. Remember that depending on what track type and or track rule you use you will get a different type of lever render.

[johnrossetti]

Wow, so simple ! many many thanks Antony, worked a treat.