Page 1 of 1
RW3 - Expert Mode
Posted: Fri Sep 23, 2011 10:47 am
by adam3544
There are some scenarios requiring Expert Mode Only.
Unfortunately, I don't find this option anywhere in the new RW3.
Thanks.
Adam
Re: RW3 - Expert Mode
Posted: Fri Sep 23, 2011 12:01 pm
by StefanSchmidt
Options-Gameplay - untick Simple Controls. Then you are in the expert mode.
I think this should be descriped in the Manuals.
Stefan
Re: RW3 - Expert Mode
Posted: Fri Sep 23, 2011 9:19 pm
by adam3544
StefanSchmidt wrote:Options-Gameplay - untick Simple Controls. Then you are in the expert mode.
I think this should be descriped in the Manuals.
Stefan
I have this setup but driving Class 86 is impossible, because in RW3 only simple mode is available on this loco.
Another bug.
Thanks Stefan.
Adam
Re: RW3 - Expert Mode
Posted: Fri Sep 23, 2011 9:59 pm
by AndyUK
The Class 86 works. I've just been driving it. Are you sure the Simple Controls box is not ticked?
Andy L
Re: RW3 - Expert Mode
Posted: Sat Sep 24, 2011 8:00 am
by adam3544
AndyUK wrote:The Class 86 works. I've just been driving it. Are you sure the Simple Controls box is not ticked?
Andy L
Yes, you're right. It works, but what a low frame rate. There are places when it drops down to 9 !!!, but usually it's around 25 with drops to 11 FPS. Is ECML optimized for the new graphics engine. Also, I found only one scenario in the list for Class 86.
Cheers,
Adam
Re: RW3 - Expert Mode
Posted: Sat Sep 24, 2011 9:10 am
by Kromaatikse
WCML-N is still on the old version AFAIK. An update to it is expected at some point which should improve it's performance and slightly extend the area it covers.