BD Denby Ore

Manty · Post by **Manty** » Wed Dec 14, 2005 1:30 pm

Don,
An excellent activity, really enjoyed it
Goes well with this excellent route.
Haven't quite finished it (time constraints) but well done
Manty

PS Anymore where that came from !!!!! although I bet that one took a while to create.

Bigant · Post by **Bigant** » Wed Dec 14, 2005 6:28 pm

Thanks Manty, glad you liked it, yes does take a while to get them working how you want, always seems to get a problem an hour into it, then have to alter it and start again

Never time them as I generally have a break from it after a couple of hours.
A perishable goods activity almost ready, takes about 1hr 40mins.

Best wishes
Don

Manty · Post by **Manty** » Wed Dec 14, 2005 7:15 pm

Will look forward to it Don
Perhaps in time to run over the Christmas period?
Happy Christmas
Manty

Bigant · Post by **Bigant** » Wed Dec 14, 2005 8:23 pm

Thanks Manty Merry Xmas to you too and anyone else reading this thread.

Am finishing an activity for Alan Scott atm as he's a bit short on time to finish it

Best wishes
Don

sddsddean · Post by **sddsddean** » Fri Dec 16, 2005 7:25 pm

Brilliant activity Don. Only sort of problem I had was when using the front coupler at the iron works. It all worked ok, but for some reason the loco, tender and 2 of the clays would not show up on f9. So I had to split the train in 3 at Denby until the loco appeared in the 'coupling' window to allow the run round. Very odd.

Simon

MikeandDi · Post by **MikeandDi** » Fri Dec 16, 2005 9:40 pm

Excellent activity, stock and route.

Completed with no problems ( although late, as usual ! )

Thanks Don

Mike

Bigant · Post by **Bigant** » Fri Dec 16, 2005 11:10 pm

Thanks All, hope to have another one uploaded tomorrow.

Yes Simon I also had to split the train at Denby

have included a little note about front coupling , hope it helped.

Best wishes
Don

lwaxl00 · Post by **lwaxl00** » Fri Dec 23, 2005 3:00 pm

Is the CD version of the route different from the downloadable one. I get loads of broken paths on this activity and when I installed the activity it says that it was built on a later version. I cant see any recent patches only the one that is in the library.

Alan L

Bigant · Post by **Bigant** » Fri Dec 23, 2005 6:21 pm

Hi Alan

Yes the CD version is a little different, track work at Toton altered, a section down to Kegworth included and several small things, like trees of the ground etc, fixed. The only paths that would be affected would be around the Toton area and anything starting or finishing at Kegworth.
So yes this activity would be affected as it starts at Toton.

Hope this helps.
Merry Xmas
Don