Rescue Log Train Problem on West Highland 2

rdawes · Post by **rdawes** » Wed Mar 03, 2004 2:03 am

Is anyone else getting an immediate "Activity Completed" when trying to leave the siding? I opened the activity in the AE and discovered that the Activity Completed area on the adjacent siding encompassed the starting siding which caused the premature ending. I moved the circle closer to the entrance and reduced it's dimensions from 10 meters to 7 which solved the problem.

Bob

sddsddean · Post by **sddsddean** » Thu Mar 04, 2004 9:18 pm

Yes, me too. So how do you do that Bob? I suppose I have to go into the realms of the Activity Editor. AAARRRGGGHH!!

Simon

rdawes · Post by **rdawes** » Sat Mar 06, 2004 4:37 am

Well Simon, you're going to have to do the unthinkable and open the activity in the AE.

After doing so, expand the starting area of the map and make sure you open the Tools (menu bar) and click "Verify Starting State." After this you will see the starting loco on its siding and the End Activity circle should be visible on the ajacent siding. Grab the circle and pull it forward towards the points and away from the starting loco. You can also right click the activity circle and reduce it's zone which I did to 7 meters from 10.

Now you're good to go.

Bob

sddsddean · Post by **sddsddean** » Sun Mar 07, 2004 4:32 pm

OK Bob, I'll give it a go.

Simon

sddsddean · Post by **sddsddean** » Mon Mar 08, 2004 7:54 pm

Excellant instructions Bob; thanks a lot.

Simon

wrighty · Post by **wrighty** » Wed Mar 10, 2004 7:17 pm

Sorry guys i will make the change and re-upload the activity.