Take other exit greyed out

spinemaligna · Post by **spinemaligna** » Wed Dec 17, 2003 1:30 pm

I am trying to crate a path in Woodhead v.2 but when I try to take the other exit the option is greyed out. I was particularly trying to take the Up slow road just south of Penistone towards Sheffield. Thinking it might have been that set of points I tried others with the same result.
Any hints.

Ross

kevarc · Post by **kevarc** » Wed Dec 17, 2003 2:55 pm

Check you path start and end points and make sure it is going in the roght direction. Been there, done that!

spinemaligna · Post by **spinemaligna** » Wed Dec 17, 2003 10:17 pm

I'm afraid its not playing ball at all. Definately will not let me take other exit from any point I've tried. Also when I am in vcr mode I can see reversing points etc. but when I go to edit a path they disappear only to be seen while moving the path editor box. It looks as though the editor is completely screwed (as are Chelseas league cup ambitions).

Ross

kevarc · Post by **kevarc** » Wed Dec 17, 2003 10:19 pm

Can you see loose consists in the AE?

If not you may need to do this:
http://www.3dtrains.com/forums/index.ph ... ca913c7bb9

spinemaligna · Post by **spinemaligna** » Wed Dec 17, 2003 11:02 pm

I could see the loose consists but had a go at the registry anyway et voila, problem solved.

Many thanks (don't understand what I've done).

Ross

jimmyladd · Post by **jimmyladd** » Thu Dec 18, 2003 12:31 pm

Could you tell me what you did to the registry and where it is?
I am having problems with reverse points making msts crash.
Cheers Jim

Fodda · Post by **Fodda** » Thu Dec 18, 2003 3:00 pm

Follow ther link in Kev's post above.