Now I do know that this may get me branded as one of those "Gimmie Pig's"
but I am desperate. As some may know I have been compiling, with the help of Cpt Bazza and Nigel Booth, a Donation ware pack for the QPSR railway in QLD australia (see http://forums.uktrainsim.com/viewtopic. ... 51&t=70049). Funds from the pack are going streight to the restoration fund of loco PB15 448 and Overhaul of Kilrie. However were missing the PB15 from the pack, Cpt Bazza and Nigel are unable to take on the PB15 due to other commitments, and my 3d design leaves much to be desired. So i am now looking for help from someone else in the MSTS community.The PB15 is a 4-6-0 tender locomotive built in 1908, with an inside Stephenson vaulve gear. I have in my possesion all the blue prints for the locomotive and I can easily get hold of photos.
Attached are some photo's taken by Graham R
Cheers and thank you all for your time
Bob