BMP to Auto Cad

RichyJ · Post by **RichyJ** » Wed Jul 30, 2003 8:06 pm

I used to have a program which would get a bmp image then allow you to plot points around it to create a basic shape. Then you could make this shape into a simple 3d image which saved as an autocad file.
I am trying to make my first loco and i no longer have this software on my system and i cannot remember what it was called. From what i remember it could make the 3d moddelling a little easier.
Can anyone remember the name of this software??

CaptainBazza · Post by **CaptainBazza** » Thu Jul 31, 2003 12:42 am

Hmmmm, yes, I seem to recollect that prog came out on a magazine cd a few years back, but not sure when, or which mag. I can't even remember if it was a fully operational demo, or timeware.

:drinking:

I knew I should have cut back sooner.........

RichyJ · Post by **RichyJ** » Thu Jul 31, 2003 8:36 pm

I found the proggy and has worked a treat, makes things a fair bit easier
thankyou

ForburyLion · Post by **ForburyLion** » Thu Jul 31, 2003 8:38 pm

Out of interest, What was the name of the programme?

Atomic Systems

BMP to Auto Cad

BMP to Auto Cad

Jolt's memory cells........