Double and single track triangles using default MSTS track

[danielw2599]

hi

can anybody tell me how to make Double and single track triangles using default MSTS track or even if its possible.

ive been experimenting, but to no joy

thx alot

Daniel

[Timcourt1]

If you use my fict ECML 3.1 route go into activity editor, check the co ordinates of the junction by grafham power station for a single triangle.
then go into RE and click the track sections to get the types and dyn track measurements.

Do the same at March where there is a double track triangle.

[micksasse]

No, fairly certain that it isn't possible, chief. You need to use at least one dynamic track section.

Strongly recommend Michael Vone's PDF guide to route-building - it may cost USD15.00 but is superb value (about 250-ish pages excellently produced). It's well worth it for this and just about any other route-building queries.

Good luck.

[danielw2599]

hi

thx everybody

ill look at Fic3.1 now

thx

Daniel

[alan2]

You mean something like this but without using Dyn track.

<IMG width="645" height="530" SRC="http://album.atomic-systems.com/showPic ... 1Prog3.JPG">

If you do I'm sorry to say I used ton's of dynamic track.

Alan Heath

[danielw2599]

hi

yes that is what i mean.

But not using x-tracks or any third party addons just default MSTS track (including dyn track).

if any one can give me a list of what track sections to use id be most gratful.

Thx

Daniel