Run-time error 6, overflow in TSTF

The MSTS 1 Route Editor can be a beast to use, but it's capable of some amazing results, here you can talk with the wizards that are building some of the fantastic routes available and learn how to make your own.

Moderator: Moderators

Locked
User avatar
bristolian
Very Active Forum Member
Posts: 1695
Joined: Thu Dec 18, 2003 10:02 pm
Location: St Ives, Cambs (Formerly from Bristol)
Contact:
Contact bristolian

Run-time error 6, overflow in TSTF

Post by bristolian »

Hello,
When trying to enter registration points in TSTF, after entering the 3rd triangulation point OS refences, I get a run-time error 6, overflow message.
How can I avoid this?

Many thanks, Bob.
Virtute Et Industrial!
Top
User avatar
spinemaligna
Established Forum Member
Posts: 304
Joined: Thu Jan 17, 2002 12:00 am
Location: East Kilbride via Nottingham and Hackney

Post by spinemaligna »

I seem to recall in the mists of time that this was a common problem in early versions and could be cured by using smaller map areas. A search of the forums may help.

Ross
Top
User avatar
bigvern
Chief Track Welder
Posts: 7705
Joined: Fri Jan 04, 2002 12:00 am
Location: Swindon, England

Post by bigvern »

ISTR lots of problems trying to position the points, trying to tell you a co-ordinate was west (or east) of the one above when it wasn't. It is so long since I used TSTF though I couldn't say for sure as for the last 18 months I've been using TS Tools.
Top
Locked

Return to “[MSTS1] Route Building”