Page 1 of 1
System crash - what happened when I tested Wigan-Widnes pt2
Posted: Thu Jan 02, 2003 9:35 pm
by jp4712
First there was (note the signal aspect)...
...then a few seconds later there was...
...and finally, a second or two after that, there was...
Now, I didn't know MSTS would do that!
Posted: Thu Jan 02, 2003 10:31 pm
by martinhodgson
It is because the crossing is not recognised by MSTS as a crossing. I therefore fails to signal it properly, which can result in crashes as you have shown
Posted: Fri Jan 03, 2003 12:03 am
by JohnEyres
This is was just my ignorance when I built these junctions on the route. Watch out at Helsby Jnc too.
Posted: Fri Jan 03, 2003 10:15 am
by 47522
That happen to me, but i didn't crash i just went striate through the 87 that was on the wrong line!!!!
Still remember the look of the driver!!! Looked as though he was sh**ing himself.