Atomic Systems

Hi i know this has been probably answered before.Keep getting a train.exe problem on some of my routes e.g london south coast,eastcoast express,westcoast express etc,they go to load screen goes black.It's not a problem with dorset coast v5 or thames mersey they load fine,i am using trainstore any help or could somebody point me to the right post where it may have been answered.
Thanks.

Are you storing route and stock? You will need to check that when you run the route you require, you will need to have everything that it needs un stored. Also make sure that no stock is aliased to stored stock otherwise you may need to unstore that aswell. In short - everything that the route uses MUST be unstored before you run it!

JasVick wrote:Are you storing route and stock? You will need to check that when you run the route you require, you will need to have everything that it needs un stored. Also make sure that no stock is aliased to stored stock otherwise you may need to unstore that as well. In short - everything that the route uses MUST be unstored before you run it!

Trainstore will do all this automatically in Easy mode - just choose any activity, or an explore mode consist, and go. As Trainstore doesn't store any of the cabview or sound files your comments about aliasing are completely wrong. Just to make it absolutely clear (again) Trainstore only stores the route (.trk), activity (.act), path (.pat), service (.srv), engine or wagon (.eng or .wag) and consist (.con) files. Everything else is left in your MSTS folders.

Have you installed the latest Tsection.dat?

Have your run any batch files after installing the routes - as an administrator if you are using Vista?

Have you checked the routes with Routeriter for missing files?

Also try turning down your settings - it could be a lack of memory.